Antonius Bros. Earns Coveted Angie’s List

Super Service Award for 2011

Angie’s List Award reflects businesses’ consistently high level of customer service

Antonius Bros., Inc. has been awarded the prestigious 2011 Angie’s List Super Service Award, an honor bestowed annually on approximately 5 percent of all the businesses rated on the nation’s leading provider of consumer reviews on local service and health providers.

Jack and I are really proud to be recognized by Angie’s List.  We have always focused to give our carpet cleaning clients the best service and treat them the way we would want to be treated.  We are honored.

“Only a fraction of the businesses rated on Angie’s List can claim the sterling service record of being a Super Service Award winner because we set a high bar,” said Angie’s List Founder Angie Hicks.  “The fact that Antonius Bros. can claim Super Service Award status speaks volumes about its dedication to consumers.”

Angie’s List Super Service Award winners have met strict eligibility requirements including earning a minimum number of client reviews, an exemplary rating from their clients and abiding by Angie’s List operational guidelines.

Ratings are updated daily on Angie’s List, but members can find the 2011 Super Service Award logo next to business names in search results on AngiesList.com .

Tile cleaning tips for you.  After Cleveland residents put ceramic tile on their floors, they need to properly take care of it.  If it is the grout is sealed properly after installation (it has to cure for 72 hours before it is sealed), it should be easy to maintain.

 How to Keep Ceramic Tile Clean

You should vacuum or sweep up with a good quality mop at least two or three times a week to avoid getting dirt, mud or sand in the grout lines.  This tends to grind in the grout mortar if you have heavy foot traffic.

Do not use floor waxes on ceramic tile or any natural stone or marble tile.This tends to build up and is really hard to remove.  If you keep it clean, you will not need anything applied to it.

Do not use any acidic or abrasive chemicals or household products on your ceramic tile.  These will cause scratches and etch the tile. No matter how weak the acid solution is, it will etch marble.  Many people use a vinegar solution to clean tile.  You must never use it on natural marble.  Read all labels or products you buy at the store to make sure they are safe to use on your floor tile.

No Acid or Abrasives on Ceramic Tile or Marble

Shower and bath room tile tend to get mildew on them if not properly ventilated.  Stagnant water will breed mildew and fungi.

The new steam mops on the market will clean tile and sanitize it.  If a lot of foot traffic, you may need to do it a couple of times a week.  Or mix a mild dish washing solution (ex. Dawn, Joy, Palmolive) in a bucket of water, wash the floor with a mop, remove excess water, and if you like, air or towel dry it.  You can buff the ceramic tile if you want a shine to it.

Once grout is stained, is difficult to remove from the grout. A stain seal can be applied in a color to match your grout or you can change the color to complement your decor.  Your floor would look brand new and would be easy to maintain in the future with these tips.

How to remove the gum from the carpet

First, if you can get an aerosol gum freeze product at the store follow the directions on the can. If that is not available, get some ice cubes, put them in a plastic bag, and press them on the gum on the carpet until it becomes brittle. When it is hard and brittle, you can pull or break it off and then vacuum. If any small bits remain you can be cut them out of the carpet, but be careful not to remove too many of the fibers. If more than small bits remain, continue with the rest of these instructions.

What to do I need to do to remove the gum in the carpet?

If gum remains in the carpet, blot with an acceptable non-flammable dry cleaning solvent such as Carbona®, Energine®, K2R®, Goof-Off®, etc. on a white towel. Always exercise caution when using dry cleaning solvents. Test first in an inconspicuous area on the carpet; If a change occurs, select another solution. Never pour directly on the carpet or you could destroy the glue holding the primary and secondary backing together. Remember to always work from the edges to the center of any spot to prevent it from spreading. DO NOT RUB! Always blot so that you do not damage the fibers of the carpet. Be patient and allow the product to remain on the gum for a few minutes to do its work.

How to remove the residue left in the carpet.

Many spot removal solutions leave residues in the carpet that may attract soil. Thoroughly rinse the area several times with lukewarm tap water. A mist type sprayer is recommended to prevent over wetting the carpet. Blot with paper towels and pat dry after each rinse. Several rinses are often necessary to thoroughly remove residues. Never use any of the solutions in concentrations stronger than those recommended on the product. And blot up any moisture as much as you can.

If we can answer any of your questions, call us at 440–845-7474 and we would be happy to assist you.